Premium 12v 2000K Flame White 90CRI 4.8W 60x3528 Epistar Chip LED Strip IP65 Splashproof (5 Metre reel)

ID: TL000FW60IP65

  • Colour=Flame White (2000K)
Was: £31.50
Now: £24.00
£28.80 (Inc. VAT)

Premium 12v 2000K Flame White 90CRI 4.8W 60x3528 Epistar Chip LED Strip IP65 Splashproof (5 Metre reel)

This is a rare 2000k 'Flame White' LED tape using a premium Epistar chip producing highest possible colour rendering in 90 CRI. This low brightness tape is perfect for creating a candlelit ambience in bars and restaurants. Supplied in an IP65 silicone sleeve.

3528 x 60 is a low brightness tape suitable for providing a soft ambient glow. Suggested applications include:

  • Kitchen cabinets
  • Plinth lighting
  • Pelmets
  • Shelf lighting
  • Handrails

It’s so easy to install due to its flexible physical size and the 3M adhesive tape on the reverse can be easily concealed. Our range of LED tape has been installed in thousands of locations and we offer one of the most comprehensive ranges of LED strip lighting on the market.

What Makes Our Tape Premium?
Our premium tapes are printed on a thicker 2 oz. PCB to help with heat dissipation and have a high quality chip producing lower light degradation. These tapes come with a strong 300 LSE 3M tape backing and have cables pre-soldered at both ends of the reel. All premium non-waterproof tapes are sold with an unprecedented five year warranty.

Premium tapes are better for long term installations and demanding commercial environments where colour rendering and long lasting brightness is essential. Standard tapes provide a great amount of performance for less cost.


  • Supplied in 5 metre reels
  • LED Type: 3528 Low Brightness Chip
  • Power Consumption: 4.8w per metre | 24w per reel
  • Lumens: 480 p/m
  • Voltage: 12v
  • Tape Width: 8mm + 2mm Silicone
  • Colour Temperature: 2000 Kelvins (flame white)
  • Number of LEDs: 60 per metre | 300 per reel
  • Water Ingress Rating: IP65 (splashproof)
  • Cut points: every 5cm
  • Dimmable: Yes
  • Warranty: 3 Year

How Do I Connect?
LED strip lights are supplied with 15cm of live wires pre-soldered on one end. If you are using one of our Standard Range Drivers you can order 1 x U2.1FEM to connect with. If you are using one of our Premium Range Drivers you can wire in directly via terminals located on the unit. (With exception to our waterproof premium drivers, which are fully sealed).

How Do I Extend?
You can use our IP65 connector block for our single colour tapes here.

What Driver do I need?
To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.

Which profile can I use?
Please note that waterproof tapes do not fit inside all of our aluminium profiles. The shallowest profile that can be used is the 17 x 8mm standard profile. Profiles described as 'Extra Deep' will also house these tapes. Please contact us if you are unsure whether a particular combo will work.

Which controller can I use? (optional)
For single colour tape you can use our Standard Range of controllers or the Elencho Wireless Control System.

Please see our FAQ for more help and useful guides.

Technical Documentation

Technical Specs