Easy to Use 24V 120 LEDs 9.6w p/m LED Tape, Neutral White 4000K IP20 (Sold per Metre)

The Bright Plus LED Strip Tape series is sold per metre for custom lengths up to 5 metres and can be bought with an Easy to Use plug and play tail for quick and easy installation.

The Easy to Use tail doesn’t require any soldering, simply snap the connector onto the end of your tape and plug in to the compatible Syndeo multiport driver. Learn more about our Syndeo plug and play lighting system here.

Alternatively, simply cut the Easy to Use plug off the 2 core wire with scissors and hard wire into a professional driver. For pre-soldered tails please request a quote.

Featuring self-adhesive backing this robust tape can be cut to any desired length at any of the allocated cut points, and can be extended if required. If there is a requirement for the strip tape to be cut into several sections we also offer additional plug & play connectors to accompany this.

Maximum runs of up to 5 metres can be achieved with this tape before voltage drops occur.

Bright Plus LED Strips use a more efficient 2835 chip, producing more lumens per watt than old style legacy strip lights currently offered in the mass market today.

24V strip tape works from a 240v mains circuit when being powered by a compatible transformer. Alternatively, the strip units can be wired to a dedicated 24V DC circuit without the need for a transformer.

To guarantee the highest efficiency, we advise that you change your existing transformers to LED Drivers guaranteeing compatibility. Please see our quick driver guide below:

What Driver do I need?

To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.

For this tape range you will require a driver which is above the below figures.

• 1 metre – More than 6w
• 2 metre – More than 11w
• 3 metre – More than 16w
• 4 metre – More than 22w
• 5 metre – More than 27w

Which profile can I use?

This LED tape can be housed in profiles with a channel width of 8mm or more. View our recommended profiles below.

Which controller can I use? (optional)

For single colour tape you can use our Standard Range of controllers.

How do I connect?

Simply plug the Easy to Use plug into one of the ports of the Syndeo multiport driver. Alternatively, you can cut the Easy to Use plug off the end of the 2-core wire with scissors and hard wire it in to one of our professional drivers.

Specifications:

• Sold per metre
• Optional 500mm 2-core tail with Easy to Use plug available
• LED Type: 2835 Chip
• Power Consumption: 9.6w per metre | 48w per reel
• Lumens: 1160 p/m
• Voltage: 24v
• Tape Width: 8mm
• Colour Temperature: 4000 Kelvins (neutral white)
• Number of LEDs: 120 per metre | 600 per reel
• CRI: >90
• Water Ingress Rating: IP20 (non waterproof)
• Cut points: every 5cm
• Ready Connect amp rating: 5Amp
• Dimmable: Yes (DALI,DMX,ELV,TRIAC,0-10V)
• Warranty: 3 Year

all products should be installed by a technically competent person in accordance with BS7671 and all other local regulations.