Premium IP65 LED Tape by Tagra®, Flame White, 12w p/m (5 Metre Reel)

ID: TL043FW60IP65

  • 2000K
  • IP65
  • 12V
  • Dimmable
  • CRI 80
Was: £59.51
Now: £24.80
£29.76 (Inc. VAT)

Premium 1440 Lumens 12V 12W Flame White 2000K 90CRI Epistar Chip 60x2835 LED Strip IP65 Splashproof (5 Metre Reel)

This is a rare 2000k 'Flame White' LED tape using a premium Epistar chip producing highest possible colour rendering in 90 CRI. This high brightness tape is perfect for creating a candle flame effect in bars and restaurants. Supplied in an IP65 silicone sleeve.

It’s so easy to install due to its flexible physical size and the 3M adhesive tape on the reverse can be easily concealed. Our range of LED tape has been installed in thousands of locations and we offer one of the most comprehensive ranges of LED strip lighting on the market.

What Makes Our Tape Premium?
Our Premium offering of tape from Tagra uses superior chips developed with a high color rendering and has a lower decay rate. It also comes with a 5 year warranty. In addition to this our premium tape has the most sticky double sided tape on the back which sticks to almost any surface and reduces the chances of falling off.

Premium tapes are better for long term installations and demanding commercial environments where colour rendering and long lasting brightness is essential. Standard tapes provide a great amount of performance for less cost.

-Standard Delivery from £3.59 inc VAT (Delivered in 2 -3 days)
-Next Day Delivery from £6.59 inc VAT (Order before 4pm - Next Working Day)


  • Supplied in 5 metre reels
  • LED Type: 2835 High Brightness Chip
  • Power Consumption: 12w per metre | 60w per reel
  • Lumens: 1320 - 1440 p/m
  • Voltage: 12v
  • Tape Width: 8mm + 2mm Silicone
  • Colour Temperature: 2000 Kelvins (flame white)
  • Number of LEDs: 60 per metre | 300 per reel
  • Water Ingress Rating: IP65 (splashproof)
  • Cut points: every 5cm
  • Dimmable: Yes
  • Warranty: 3 Year

How Do I Connect?
LED strip lights are supplied with 15cm of live wires pre-soldered on one end. If you are using one of our Standard Range Drivers you can order 1 x U2.1FEM to connect with. If you are using one of our Premium Range Drivers you can wire in directly via terminals located on the unit. (With exception to our waterproof premium drivers, which are fully sealed).

How Do I Extend?
You can use our IP65 connector block for our single colour tapes.

Which profile can I use?
Please note that waterproof tapes do not fit inside all of our aluminium profiles. The shallowest profile that can be used is the 17 x 8mm standard profile. Profiles described as 'Extra Deep' will also house these tapes. Please contact us if you are unsure whether a particular combo will work.

What Driver do I need?
To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.

Which controller can I use? (optional)
For single colour tape you can use our Standard Range of controllers or the Elencho Wireless Control System.

Technical Documentation

Technical Specs