Our Professional Pro Bright tapes are manufactured using the highest-quality chips producing lower light degradation and offering premium colour rendering. Printed on a thicker 2oz. PCB to help with heat dissipation, these tapes come with a strong 300 LSE 3M tape backing and have 2-core cables pre-soldered at both ends of the reel ready for hard wiring in to the compatible driver.
Ready to Connect tails are also available upon request.
This 5 metre reel can be cut to your desired length at any of the allocated cut points. Please note: A silicone end cap must be glued on to reseal the end once the tape is cut to maintain its IP rating. End cap kits sold separately.
Maximum runs of up to 5 metres can be achieved with this tape before visible voltage drops occur.
All premium water resistant tapes are sold with a three-year guarantee subject to correct installation for peace of mind.
What Driver do I need?
To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.
How do I connect?
The 2-core tail can be hard wired into the terminals of the compatible driver. For a plug and play system please request a bespoke quote. You can also solder director to the PCB Pads. Warning: Not suitable for clip on connectors.
Which profile can I use?
This LED tape can be housed in profiles with a channel width of 8mm or more. View our recommended profiles below.
Which controller can I use? (optional)
For single colour tape you can use our Standard Range of controllers.
Please see our FAQ for more help and useful guides, alternatively contact us for technical help.
all products should be installed by a technically competent person in accordance with BS7671 and all other local regulations.