The Extra Wide plaster-in profile adds to our extremely popular range. Now featuring an internal width of 33mm which will allow you to run 3 separate lengths of 10mm wide LED tape. Ideally used in large residential homes, these profiles can produce a huge amount lumens if accompanied with the correct tape.
Plaster in extrusions - trimless profiles for recessing into plastered walls and ceilings for an incredible seamless diffused light output.
This innovative product is designed to plaster in to plaster board for an beautiful seamless lighting effect. Available in 2 and 3m lengths or custom mitred lengths.
Simply screw the profile into 10mm drywall and plaster over then add the diffuser.
These Aluminium Channels are suitable for housing and protecting our LED strips. They allow a flush install into grooves or furniture pieces as well as prevent the much unwanted secondary refraction from reflective surfaces. They also act as a heat sink for them as well, which in turn will increase the LEDs lifetime as well as slowing down any brightness degradation over time.
Diffusers will affect the brightness of LED tapes when installed, as a general guide, please see the information below on how much the brightness is affected by each type of diffuser.
Transparent: 5-10% of the brightness will be taken away
Semi-Clear: 25-30% of the brightness will be taken away
Opal: 50-55% of the brightness will be taken away
Black: 65-70% of the brightness will be taken away
Ultra LEDs are one of just a few providers in the UK to supply custom channel lengths for easier installation
• Dimensions: 98x18mm
• Max Tape Width: 33mm (3 x 10mm IP20 tape)
• Material: Anodized Aluminium
• Can be recessed into plasterboard
• End caps available
Please Note: Non Spotting on the recommended diffuser only occurs and applies when used with one of our LED Tapes at 120 LEDs per metre or more.